Allied Telesis AT-S62 - Manual (Page 230)

Chapter 12: Event Log and Syslog Servers
230 Section II: Advanced Operations
Figure 64. Configure Log Outputs Menu with a Syslog Server Definition
8. Repeat this procedure starting with step 4 to create additional syslog
server definitions, if needed.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying a
Syslog Server
Definition
To modify a syslog server definition, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 60 on page 218.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 62 on page 223.
4. Type 2 to select Modify Log Output.
The following prompt is displayed:
Enter output ID to modify [1 to 20] -> 1
5. Enter the ID number of the syslog server definition you want to modify.
The Syslog Server Configuration menu is shown in Figure 63 on page
226. The menu contains the specifications of the selected definition.
6. Modify the settings as needed.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Configure Log Outputs
OutputIDType Status Details
-----------------------------------------------------------
1
Temporary Enabled Wrap on Full
2 Syslog Enabled 149.44.44.44
1 - Create Log Output
2 - Modify Log Output
3 - Delete Log Output
4 - View Log Output Details
R - Return to Previous Menu
Enter your selection?