Allied Telesis AT-S62 - Manual (Page 436)

Chapter 21: SNMPv3
436 Section III: SNMPv3
Configuring the SNMPv3 Target Address Table
This section contains a description of the SNMPv3 Target Address Table
Menu and how to create, delete, and modify table entries. You use the
SNMPv3 Target Address Table Menu to assign the IP address of a host
that is used for generating notifications. The Configure SNMPv3 Target
Address Table Menu is linked internally to the Configure SNMPv3 Notify
Table through the Tag List parameter. The Configure SNMPv3 Notify
Table Menu receives the host IP address through the configuration of the
SNMPv3 Target Address Table Menu.
For each Target Address Table entry, you can configure the following
parameters:
ˆ Target Address Name
ˆ Target IP Address
ˆ UDP Port
ˆ Timeout Value
ˆ Number of Retries
ˆ Tag List
ˆ Target Parameters
ˆ Storage Type
You must configure the Tag List parameter with values previously
configured in the Notify Tag parameter. The Notify Tag parameter is
located on the Notify Table Menu. See “Creating an SNMPv3 Notify Table
Entry” on page 429.
There are three functions you can perform with the Configure SNMPv3
Target Address Table Menu.
ˆ “Creating an SNMPv3 Target Address Table Entry” on page 437
ˆ “Deleting an SNMPv3 Target Address Table Entry” on page 439
ˆ “Modifying an SNMPv3 Target Address Table Entry” on page 440