Allied Telesis AT-S62 - Manual (Page 197)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 197
Note
The “2 - Stacking Services” selection is only available on a master
switch.
The Stacking Services menu is shown in Figure 16 on page 85.
3. Type 1 to select Get/Refresh List of Switches. The master switch polls
the subnet for the switches in its enhanced stack and displays the
switches in the Stacking Services menu.
4. Type 4 to select Load Image/Bootloader File.
The following prompt is displayed:
Enter the list of switches ->
5. Enter the number (Num column in the menu) of the AT-8500 Series
switch whose software you want to update. You can specify more than
one switch at a time (for example, 2,4,5).
Note
The AT-S62 image file is only supported on AT-8500 Series
switches.
The following prompt is displayed:
Do you want to show remote switch burning flash -> [Yes/
No]
6. You can respond with Yes or No to this prompt. It does not affect the
upload.
The following prompt is displayed:
Do you want confirmation before downloading each switch
-> [Yes/No]
7. If you answer Yes to this prompt, the management software displays a
confirmation message before uploading the image file to a switch. If
you answer No, the management software does not display a
confirmation prompt before uploading the file.
The management software begins the upload. The management
software notifies you when the upload is complete.
After receiving the file, a switch compares the version numbers of the
new and existing image files. If the new image file has the same or an
earlier version number as the file in the application block, the switch
cancels the update process. If the new image file has a newer version
number, the switch writes the file to the application block portion of
flash memory and then resets.