Allied Telesis AT-S62 - Manual (Page 56)

Chapter 3: Basic Switch Parameters
56 Section I: Basic Operations
To activate or deactivate the BOOTP or DHCP client software, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 2 to select System
Configuration.
The System Configuration menu is shown in Figure 5 on page 53.
3. From the System Configuration menu, type 1 to select BOOTP/DHCP.
The following prompt is displayed:
DHCP/BOOTP/DISABLE (1-DHCP, 2-BOOTP, 3-DISABLE) :
4. Type 1 to activate DHCP, 2 to activate BOOTP, or 3 to disable both
application protocols. The default is disabled.
Note
If you activate the BOOTP or DHCP client software, the switch
immediately begins to query the network for the corresponding
server. The switch continues to query the network for its IP
configuration until it receives a response.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.