Allied Telesis AT-S62 - Manual (Page 565)

AT-S62 Management Software Menus Interface User’s Guide
Section V: VLANs 565
Modifying a VLAN
You can use this procedure to add or remove ports from a port-based or
tagged VLAN. You can also use this procedure to change a VLAN’s name.
Note
To modify a VLAN, you need to know its VID. To view VLAN VIDs,
refer to “Displaying VLANs” on page 569.
To modify a VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 188 on page 559.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 189 on page 560.
Note
If option “4 - Configure VLANs” is not displayed in the menu, the
switch is running a multiple VLAN mode. To change a switch’s VLAN
mode, refer to “Selecting a VLAN Mode” on page 612.
3. From the Configure VLANs menu, type 2 to select Modify VLAN.
The Modify VLAN menu is shown in Figure 191.
Figure 191. Modify VLAN Menu
Option 2 - Change GARP VLAN is described in “Converting a Dynamic
GVRP VLAN” on page 596.
4. Type 1 to select VLAN ID (VID).
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Modify VLAN
1 - VLAN ID (VID) ........
2 - Change GARP VLAN
R - Return to Previous Menu
Enter your selection?