beautypg.com

Allied Telesis AT-S62 User Manual

Page 219

background image

AT-S62 Management Software Menus Interface User’s Guide

Section II: Advanced Operations

219

2 - Display Output
Selects an event log. This option has only one selection, Temporary.
The event log is located in temporary memory.

3- Display Order
Controls the order of the events in the log. Choices are Chronological,
which displays the events in the order oldest to newest, and Reverse
Chronological, which displays the events newest to oldest. The default
is Chronological.

4 - Display Mode
Controls the format of the event log. Choices are Normal, which
displays the time, module, severity, and description for each event, and
Full, which displays the same information as Normal, plus filename,
line number, and event ID. The default is Normal. For an example of
the display and definitions of the information, refer to Figure 61 on
page 221.

5 - Display Severity
Displays events of a selected severity. Event severity is a predefined
value assigned to an event according to its potential impact on switch
operation. There are four severity levels, as defined in Table 4. The
default is informational, error, and warning. You can specify more than
one severity (for example, E,W).

6 - Display Module
Displays events of a selected AT-S62 module. The AT-S62
management software consists of a number of modules, each
responsible for a different part of switch operation. You can instruct the
switch to display only those events that apply to selected modules. The
default is ALL, which displays the events for all modules. The modules
are listed in Table 5.

Table 4. Event Log Severity Levels

Value

Severity Level

Description

ALL

-

Selects all severity levels

E

Error

Switch operation is severely impaired.

W

Warning

An issue may require manager attention.

I

Information

Useful information that can be ignored
during normal operation.

D

Debug

Messages intended for Technical Support
and Software Development.