Allied Telesis AT-S62 - Manual (Page 432)

Chapter 21: SNMPv3
432 Section III: SNMPv3
The Configure SNMPv3 Notify Table Menu is shown in Figure 142 on
page 430.
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 SecurityToGroup Table Menu, type N to display
the Next Page and P to display the previous page.
3. To delete an SNMPv3 Notify Table entry, type 2 to select Delete
SNMPv3 Table Entry.
The following prompt is displayed:
Enter Notify Name:
4. Enter a Notify Name.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N): [Yes/No]->
5. Enter Y to delete the SNMPv3 Notify Table entry or N to save it.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Notify
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. See the following procedures:
ˆ “Modifying a Notify Tag” on page 432
ˆ “Modifying a Notify Type” on page 434
ˆ “Modifying a Storage Type” on page 435
Modifying a Notify Tag
To modify the Notify Tag parameter in an SNMPv3 Notify Table entry,
perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 6 to select Configure
SNMPv3 Notify Table.
The Configure SNMPv3 Notify Table Menu is shown in Figure 142 on
page 430.