Allied Telesis AT-S62 - Manual (Page 764)

Chapter 35: Management Access Control List
764 Section VII: Management Security
Enabling or Disabling the Management ACL
This procedure enables and disables the management ACL. When
enabled, only those management stations specified in the ACL are
allowed to manage the switch remotely using the Telnet application
protocol or a web browser. When the feature is disabled, the management
software on the switch can be accessed remotely from any management
workstation.
Note
Do not activate the management ACL from a remote management
session until you have specified the access control entries (ACEs).
Otherwise, the switch will discard all remote management packets,
making it impossible for you to remotely manage the unit from a
Telnet or web browser management session. For instructions on
how to add ACEs, refer to “Creating an ACE” on page 766.
To enable or disable the Management ACL, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 7 to select Management
ACL.
The Management ACL Configuration menu is shown in Figure 260.
Figure 260. Management ACL Configuration Menu
3. Type 1 to select Management ACL Status and toggle the selection to
either Enabled or Disabled. The default setting is disabled.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Marketing
User: Manager 11:20:02 02-Mar-2006
Management ACL Configuration
Configuring Management ACL
1 - Management ACL Status ........... Disabled
2 - Create Management ACL Entry
3 - Modify Management ACL Entry
4 - Delete Management ACL Entry
5 - Display All Management ACL Entries
R - Return to Previous Menu
Enter your selection?