Figure 143: modify snmpv3 notify table menu – Allied Telesis AT-S62 User Manual
Page 433
AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3
433
3. From the Configure SNMPv3 Notify Table Menu, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Notify Table Menu is displayed as shown in
Figure 143.
Figure 143. Modify SNMPv3 Notify Table Menu
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 SecurityToGroup Table Menu, type N to display
the Next Page and P to display the previous page.
4. To modify the Notify Tag, type 1 to select Set Notify Tag.
The following prompt is displayed:
Enter Notify Name:
5. Enter a Notify Name.
The following prompt is displayed:
Enter Notify Tag:
6. Enter the new Notify Tag.
Enter an alphanumeric value of up to 32 characters.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager
11:20:02 02-Jan-2006
Modify SNMPv3 Notify Table
Notify Name ................... softwareeengineering
Notify Tag..................... softwareeengineeringtag
Notify Type.................... Inform
Storage Type .................. NonVolatile
Row Status .................... Active
1 - Set Notify Tag
2 - Set Notify Type
3 - Set Storage Type
N - Next Page
U - Update Display
R - Return to Previous Menu
Enter your selection?