Allied Telesis AT-S62 - Manual (Page 401)

AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3 401
4. To modify the Subtree Mask for this view, type 1 to select Set Subtree
Mask.
The following prompt is displayed:
Enter View Name:
5. Enter an existing View Name.
The following prompt is displayed:
Enter View Subtree (OID format/Text Name):
6. Enter Subtree that this view will or will not be permitted to display.
You can enter either a numeric value in hex format or the equivalent
text name. For example, the OID hex format for TCP/IP is:
1.3.6.1.2.1.6
The text format is for TCP/IP is:
tcp
The following prompt is displayed:
Enter Subtree Mask (Hex format):
7. Enter a Subtree Mask.
This is an optional parameter that is used to further refine the value in
the View Subtree parameter. This parameter is in binary format.
The View Subtree parameter defines a MIB View and the Subtree
Mask further restricts a user’s view, for example, to a specific row of
the MIB tree. The value of the Subnet Mask parameter is dependent
on the subtree you select. See RFC 2575 for detailed information
about defining a subnet mask.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying a View Type
To modify the View Type parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.