Allied Telesis AT-S62 - Manual (Page 463)

AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3 463
For each SNMPv3 Community Table entry, you can configure the
following parameters:
ˆ Community Index
ˆ Community Name
ˆ Security Name
ˆ Transport Tag
ˆ Storage Type
In addition, you can display the entries configured with the Configure
SNMPv1 & SNMPv2c Community Menu in the Configure SNMPv3
Community Table Menu. However, you cannot modify an SNMPv1 &
SNMPv2c Community Table entry with the Configure SNMPv3 Community
Table Menu.
There are three functions you can perform with the Configure SNMPv3
Target
Parameters Table Menu.
ˆ “Creating an SNMPv3 Community Table Entry” on page 463
ˆ “Deleting an SNMPv3 Community Table Entry” on page 466
ˆ “Modifying an SNMPv3 Community Table Entry” on page 467
Creating an
SNMPv3
Community
Table Entry
To create an entry in the Configure SNMPv3 Community Table Menu,
perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 9 to select Configure
SNMPv3 Community Table.