Allied Telesis AT-S62 - Manual (Page 572)

Chapter 24: Port-based and Tagged Virtual LANs
572 Section V: VLANs
5. Enter the VID of the VLAN you want to delete. You can specify only
one VID at a time.
Note
You cannot delete the Default_VLAN, which has a VID of 1.
The Delete VLAN menu expands to contain all relevant information
about the VLAN, as shown in Figure 195.
Figure 195. Expanded Delete VLAN Menu
6. Type D to delete the VLAN or R to cancel the procedure.
If you select to delete the VLAN, the following confirmation prompt is
displayed:
Are you sure you want to delete this VLAN [Yes/No] ->
7. Type Y to delete the VLAN or N to cancel the procedure. Press Return.
If you select Yes, the VLAN is deleted and the following message is
displayed:
SUCCESS
Please make sure to manually delete any static
multicast MAC address(es) entries for this VLAN
Press any key to continue ...
All untagged ports in the deleted VLAN are returned to the
Default_VLAN as untagged ports.
Any static addresses assigned to the ports of the VLAN are now
obsolete, since the VLAN has been deleted. Those addresses should
be deleted from the MAC address table. For instructions on how to
delete addresses, refer to “Deleting Unicast and Multicast MAC
Addresses” on page 132.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Delete VLAN
1 - VLAN Name .............. Sales
2 - VLAN ID (VID) .......... 3
3 - VLAN Type .............. Port Based
4 - Tagged Ports ........... 7,9
5 - Untagged Ports ......... 20-24
6 - Protected Ports ........ No
D - Delete VLAN
R - Return to Previous Menu
Enter your selection?