Allied Telesis AT-S62 - Manual (Page 223)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 223
The Configure Log Outputs menu is shown in Figure 62.
Figure 62. Configure Log Outputs Menu
This menu includes any syslog servers you might have defined.
4. Type 2 to select Modify Log Output.
The following prompt is displayed:
Enter output ID to modify [1 to 20] -> 1
5. Press Return to accept the default value 1.
The following prompt is displayed:
Enter new log full action (1-Wrap on Full, 2-Halt on Full)
->
6. Type 1 if you want the switch to delete the oldest entries as it adds new
entries, or 2 if the switch is to stop adding entries when the log reaches
maximum capacity.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Configure Log Outputs
OutputID Type Status Details
-----------------------------------------------------------
1
Temporary Enabled Wrap on Full
1 - Create Log Output
2 - Modify Log Output
3 - Delete Log Output
4 - View Log Output Details
R - Return to Previous Menu
Enter your selection?