Allied Telesis AT-S62 - Manual (Page 755)

AT-S62 Management Software Menus Interface User’s Guide
Section VII: Management Security 755
Configuring RADIUS Authentication Protocol Settings
To configure the RADIUS settings on the switch, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 6 to select Authentication
Configuration.
The Authentication Menu is shown in Figure 255 on page 752.
Note
Option 1 - Server-based Authentication in the menu applies only to
the manager accounts feature described in this chapter. This menu
selection has no affect on the 802.1x port-based access control
feature described in Chapter 29, “802.1x Port-based Network
Access Control” on page 643. When Option 1 is set to disabled, the
default setting, the switch uses the default manager and operator
accounts. When set to enabled, the switch seeks its manager
accounts on a TACACS+ or RADIUS authentication server.
3. To select the active authentication protocol, type 2 to select
Authentication Method. The following prompt is displayed:
Enter T-TACACS+, R-RADIUS ->
4. Type R for RADIUS. Only one protocol can be active on the switch at a
time.
5. To configure the RADIUS parameters, type 4 to select RADIUS
Configuration.