Allied Telesis AT-S62 - Manual (Page 752)

Chapter 34: TACACS+ and RADIUS Authentication Protocols
752 Section VII: Management Security
Configuring TACACS+ Authentication Protocol Settings
To configure the TACACS+ settings on the switch, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 6 to select Authentication
Configuration.
The Authentication Configuration menu is shown in Figure 255.
Figure 255. Authentication Configuration Menu
Note
Option 1 - Server-based Authentication in the menu applies only to
the manager accounts feature described in this chapter. This menu
selection has no affect on the 802.1x port-based access control
feature described in Chapter 29, “802.1x Port-based Network
Access Control” on page 643. When Option 1 is set to disabled, the
default setting, the switch uses the default manager and operator
accounts. When set to enabled, the switch seeks its manager
accounts on a TACACS+ or RADIUS authentication server.
3. To select the active authentication protocol, type 2 to select
Authentication Method. The following prompt is displayed:
Enter T-TACACS+, R-RADIUS ->
4. Type T to select TACACS+. The default is TACACS+. Only one
protocol can be active on the switch at a time.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Authentication Menu
1 - Server-based Authentication ..... Disabled
2 - Authentication Method ........... TACACS+
3 - TACACS+ Configuration
4 - RADIUS Configuration
5 - Passwords Configuration
R - Return to Previous Menu
Enter your selection?