Allied Telesis AT-S62 - Manual (Page 200)

Chapter 11: File Downloads and Uploads
200 Section II: Advanced Operations
Caution
This procedure causes the switch to reset. Some network traffic may
be lost.
To upload a boot configuration file from the master switch to another
switch in an enhanced stack, perform the following procedure:
1. From the Main Menu, type 8 to select Enhanced Stacking.
The Enhanced Stacking menu is shown in Figure 15 on page 84.
2. From the Enhanced Stacking menu, type 2 to select Stacking
Services.
Note
The “2 - Stacking Services” selection is only available on master
switches.
The Stacking Services menu is shown in Figure 16 on page 85.
3. Type 1 to select Get/Refresh List of Switches. The master switch polls
the network for all enhanced stacking switches in the subnet and
displays the switches in the Stacking Services menu.
4. Type 5 to select Load Configuration File.
The following prompt is displayed:
Remote switches will reboot after load is complete
Do you want to load the last saved master configuration?
[Yes/No] ->
5. If you want the master switch to upload its active boot configuration file
onto the other switch, type Y for yes and go to step 7. If you want the
master switch to upload another configuration file from its file system,
type N for no.
The following prompt is displayed:
Enter the configuration file name ->
6. Enter the name of the configuration file on the master switch you want
to upload. The name must include the suffix “.cfg”. (To view the names
of the configuration files, refer to “Displaying System Files” on
page 185.)
The following prompt is displayed:
Enter the list of switches ->