Allied Telesis AT-S62 - Manual (Page 429)

AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3 429
Configuring the SNMPv3 Notify Table
This section contains a description of the SNMPv3 Notify Table Menu and
how to create, delete, and modify table entries. The Configure SNMPv3
Notify Table Menu allows you to define a name for sending traps. In each
Notify Table entry, you define if the switch sends a trap or an inform
message. The two message types, trap and inform, have different packet
formats.
For each Notify group, you can configure:
ˆ Notify Name
ˆ Notify Tag
ˆ Notify Type
ˆ Storage Type
The value of the Notify Tag is linked with the Tag List parameter in the
Configure SNMPv3 Target Address Table Menu. After you configure a
value for the Notify Tag parameter, you use the same value in the Target
List parameter that is located on the Target Address Table Menu. As a
result of this connection between the two tables, the Notify Tag parameter
assigns a Target IP address to the Notify Table internally.
There are three functions you can perform with the Configure SNMPv3
Notify Table Menu.
ˆ “Creating an SNMPv3 Notify Table Entry” on page 429
ˆ “Deleting an SNMPv3 Notify Table Entry” on page 431
ˆ “Modifying an SNMPv3 Notify Table Entry” on page 432
Creating an
SNMPv3 Notify
Table Entry
To create an entry in the SNMPv3 Notify Table Menu, perform the
following procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 6 to select Configure
SNMPv3 Notify Table.