Allied Telesis AT-S62 User Manual

Page 402

Chapter 21: SNMPv3

402

Section III: SNMPv3

2. From the Configure SNMPv3 Table Menu, type 3 to select Configure

SNMPv3 View Table.

3. From the Configure SNMPv3 View Table Menu, type 3 to select Modify

SNMPv3 Table Entry.

The Modify SNMPv3 Table Menu is shown in Figure 137 on page 400.

4. To modify the View Type, type 2 to select Set View Type.

The following prompt is displayed:

Enter View Name:

5. Enter a View Name that was previously configured.

The following prompt is displayed:

Enter View Subtree (OID format/Text Name):

6. Enter the View Subtree value for this View Name.

You can enter either a numeric value in hex format or the equivalent
text name. For example, the OID hex format for TCP/IP is:

1.3.6.1.2.1.6

The text format is for TCP/IP is:

tcp

The following prompt is displayed:

Enter View Type [I-Included, E-Excluded]:

7. Choose one of the following view types:

I - Included
Enter this value to permit the View Name to see the subtree specified
above.

E - Excluded
Enter this value to not permit the View Name to see the subtree
specified above.

8. After making changes, type R until you return to the Main Menu. Then

type S to select Save Configuration Changes.