Allied Telesis AT-S62 - Manual (Page 445)

AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3 445
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32-
alphanumeric characters.
The following prompt is displayed:
Enter Retries:[0 to 255]-> 3
6. Enter the number of times the switch will retry, or resend, the Inform
message.
The range is 0 to 255 retries. The default is 3 retries.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Target Address Tag List
To modify the Target Address Tag List parameter in an SNMPv3 Target
Address Table entry, perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 7 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table Menu is shown in Figure
144 on page 437.
3. From the Configure SNMPv3 Target Address Table Menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table Menu is shown in Figure
145 on page 441.
4. To modify the Target Address Tag List, type 5 to select Set Target
Address TagList.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32-
alphanumeric characters.