Allied Telesis AT-S62 - Manual (Page 467)

AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3 467
Modifying an
SNMPv3
Community
Table Entry
For each entry in the SNMPv3 Community Table, you can modify the
following parameters:
ˆ Community Name
ˆ Security Name
ˆ Transport Tag
ˆ Storage Type
However, you cannot modify the Community Index parameter.
Although you can display the SNMPv1 and SNMPv2c configuration
created with the procedures described in Chapter 5: “SNMPv1 and
SNMPv2c Configuration” on page 89, you cannot modify these
Community Table entries with the SNMPv3 Tables.
See the following procedures:
ˆ “Modifying the Community Name” on page 467
ˆ “Modifying the Security Name” on page 469
ˆ “Modifying the Transport Tag” on page 469
ˆ “Modifying the Storage Type” on page 470
Modifying the Community Name
To modify the Community Name parameter in an SNMPv3 Community
Table entry, perform the following procedure:
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 9 to select Configure
SNMPv3 Community Table.
The Configure SNMPv3 Community Table Menu is shown in Figure
148 on page 464.
3. From the Configure SNMPv3 Community Table, type 3 to select Modify
SNMPv3 Table Entry.