Allied Telesis AT-S62 - Manual (Page 210)

Chapter 11: File Downloads and Uploads
210 Section II: Advanced Operations
These guidelines apply to a TFTP upload:
ˆ Your network must have a node with the TFTP server software.
ˆ You should start the TFTP server software before beginning the
download procedure.
ˆ The switch must have an IP address and subnet mask, such as a
master switch of an enhanced stack. For switches that do not have an
IP address, such as slave switches, you can perform the upload from a
local management session of the switch using Xmodem.
Uploading a File
from a Local
Management
Session
Review “Guidelines” on page 209 before performing this procedure.
To upload a system file from a switch to a workstation or TFTP server from
a local management session using Xmodem or TFTP, perform the
following procedure:
1. Establish a local management session on the switch where you want
to upload the system file.
2. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
3. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 6 on page 57.
4. For the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 51 on page
190.
5. Type 4 to select Upload a File.
The following prompt is displayed:
Upload Method/Protocol [X-Xmodem, T-TFTP]:
6. To upload a system file using Xmodem, go to Step 7. To upload a file
using TFTP, do the following:
a. Type T.
The following prompt is displayed:
TFTP Server IP address:
b. Enter the IP address of the TFTP server.