Allied Telesis AT-S62 - Manual (Page 384)

Chapter 21: SNMPv3
384 Section III: SNMPv3
SNMPv3 View Table, SNMPv3 Access Table, and SNMPv3
SecurityToGroup Table. Lastly, you can configure a storage type for this
table entry which allows you to save the entry to flash memory.
SNMPv3 Community Table
The Configure SNMPv3 Community Table Menu allows you to configure
SNMPv1 and SNMPv2c communities. If you are going to use the SNMPv3
Tables to configure SNMPv1 and SNMPv2c communities, start with the
SNMPv3 Community Table. See “Configuring the SNMPv3 Community
Table” on page 462.
Note
Allied Telesyn recommends that you use the procedures described
in Chapter 5: “SNMPv1 and SNMPv2c Configuration” on page 89 to
configure the SNMPv1 and SNMPv2c protocols.
SNMPv3
Configuration
Example
You may want to have two classes of SNMPv3 users—Managers and
Operators. In this scenario, you would configure one group, called
Managers, with full access privileges. Then you would configure a second
group, called Operators, with monitoring privileges only. For a detailed
example of this configuration, see Appendix B, “SNMPv3 Configuration
Examples” on page 799.