Allied Telesis AT-S62 - Manual (Page 364)

Chapter 20: Networking Stack
364 Section II: Advanced Operations
The switch begins to add new entries to the table as it performs new
management functions in conjunction with other network devices.
Configuring the
ARP Table
Timeout Value
Inactive temporary entries in the ARP table are timed out according to the
ARP cache timeout value. This parameter prevents the table from
becoming full with inactive entries. The default setting is 400 seconds. To
set this value, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 2 to select System
Configuration.
The System Configuration menu is shown in Figure 5 on page 53.
3. From the System Configuration menu, type A to select ARP Cache
Timeout.
The following prompt is displayed:
Enter your new value -> [1 to 260000] -> 400 seconds
4. Enter the new timeout value in seconds. The range is 1 to 260,000
seconds. The default is 400 seconds.
A new timeout value takes affect immediately on the switch.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.