Allied Telesis AT-S62 - Manual (Page 315)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 315
Menu option 1 cannot be changed.
5. Type 2 to select Priority (0 - 7). The following prompt is displayed:
Enter new value -> [0 to 7]
6. Enter the new temporary priority value of 0 to 7 for the untagged
frames received on the port. For example, to assign a temporary
priority level of 4 to the ingress untagged packets, enter 4. The default
is 0. (If you perform Step 7 and override the priority level in ingress
tagged packets, this temporary priority value will also apply to those
packets as well.)
7. If you are configuring a tagged port and you want the switch to ignore
the priority tag in ingress tagged frames, type 3 to select Override
Priority and type Y.
All ingress tagged frames use the temporary priority level specified in
Step 6.
Note
The tagged information in a frame is not changed as the frame
traverses the switch. A tagged frame leaves a switch with the same
priority level that it had when it entered.
The default for this parameter is No, meaning that the priority level of
tagged frames is determined by the priority level specified in the frame
itself.
8. Type C to select Configure Port COS Priorities. A change to a CoS
setting is immediately activated on the port.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.