Allied Telesis AT-S62 - Manual (Page 403)

AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3 403
Modifying a Storage Type
To modify the Storage Type parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 3 to select Configure
SNMPv3 View Table.
The Configure SNMPv3 View Table Menu is shown in Figure 136 on
page 397.
3. From the Configure SNMPv3 View Table Menu, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Table Menu is shown in Figure 137 on page 400.
4. To modify the storage type, type 3 to select Set Storage Type.
The following prompt is displayed:
Enter View Name:
5. Enter the View Name you want to modify.
The following prompt is displayed:
Enter View Subtree (OID format/Text Name):
6. Enter the View Subtree for this View Name.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-Nonvolatile]:
7. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 View Table to the configuration file. After making changes
to an SNMPv3 View Table entry with a Volatile storage type, the S -
Save Configuration Changes option does not appear on the Main
Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 View Table to the configuration file. After making changes to
an SNMPv3 View Table entry with a NonVolatile storage type, the S -