Allied Telesis AT-S62 - Manual (Page 636)

Chapter 28: MAC Address-based Port Security
636 Section VI: Port Security
ˆ Discard the invalid frame and send an SNMP trap. (SNMP must be
enabled on the switch for the trap to be sent.)
ˆ Discard the invalid frame, send an SNMP trap, and disable the port.
Guidelines
Here are the guidelines to observe when using this type of port security:
ˆ This security method only applies to ingress packets on a port and not
to egress packets.
ˆ MAC address security can be set from a local, Telnet, or SSH
management session, but not from a web browser management
session.
ˆ You cannot use MAC address security and 802.1x port-based access
control on a port at the same time. To configure a port as an
Authenticator or Supplicant in 802.1x port-based access control, you
must set its MAC address security level to Automatic.
ˆ This type of port security is not supported on optional GBIC and SFP
modules.