Allied Telesis AT-S62 - Manual (Page 591)

AT-S62 Management Software Menus Interface User’s Guide
Section V: VLANs 591
Configuring GVRP
This section contains the procedure for configuring GVRP. The timers in
the following menus are in increments of centi seconds, which are
hundredths of a second.
To configure GVRP, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 188 on page 559.
2. From the VLAN Configuration menu, type 8 to select Configure GARP-
GVRP.
The GARP-GVRP Menu is shown in Figure 200.
Figure 200. GARP-GVRP Menu
3. Type 1 - GVRP Status to enable or disable GVRP.
The following prompt is displayed:
Enter your new value (E-Enabled, D-Disabled):
4. Choose one of the following:
E to enable GVRP.
D to disable GVRP. This is the default setting.
5. Type 2 - GVRP GIP Status to enable or disable GIP.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
GARP-GVRP Menu
1 - GVRP Status ........... Disabled
2 - GVRP GIP Status ....... Enabled
3 - GVRP Join Timer ....... 20
4 - GVRP Leave Timer ...... 60
5 - GVRP Leave All Timer .. 1000
P - GVRP Port Parameters
O - Other GVRP Parameters Menu
D - Reset GVRP to Defaults
R - Return to Previous Menu
Enter your selection?