Allied Telesis AT-S62 - Manual (Page 365)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 365
Displaying the Routing Table
The routing table is used by the switch when the IP address of a remote
node specified in a management command is not on the same physical
network as the switch. The table contains the IP address of the next hop to
reaching the remote network or device. For example, the switch might
refer to the table if you instructed it to download a new AT-S62 image file
from a network server that was on a different physical network.
To view the route table, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 6 on page 57.
3. From the System Utilities menu, type 6 to select Networking Stack.
The Networking Stack menu is shown in Figure 124 on page 361.
4. From the Networking Stack menu, type 4 to select Display Route
Table.
The Display Route Table is shown in Figure 126.
Figure 126. Display Route Table
Allied Telesyn Ethernet Switch AT-8524POE - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Display Route Table
Destination Mask Next Hop Interface
---------------------------------------------------------------
127.0.0.0
255.0.0.0 127.0.0.1 loopback
169.254.0.0 255.255.0.0 169.254.37.1 eth0
169.254.37.1 255.255.255.255 127.0.0.1 loopback
U - Update Display
R - Return to Previous Menu
Enter your selection?