Allied Telesis AT-S62 - Manual (Page 363)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 363
Deleting an ARP
Entry
To delete an entry from the ARP table, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 6 on page 57.
3. From the System Utilities menu, type 6 to select Networking Stack.
The Networking Stack menu is shown in Figure 124 on page 361.
4. From the Networking Stack menu, type 2 to select Delete ARP Entry.
The following prompt is displayed:
Enter IP address of the ARP entry to delete:
5. Enter the IP address of the entry you want to delete. You cannot delete
the first entry in the table with the interface designation “loopback.”
The entry is immediately removed from the switch.
6. Repeat steps 4 and 5 to delete additional ARP table entries.
You do not need to return to the main menu to save the changes made
with this procedure.
Deleting All ARP
Entries
To delete all entries from the ARP table, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 6 on page 57.
3. From the System Utilities menu, type 6 to select Networking Stack.
The Networking Stack menu is shown in Figure 124 on page 361.
4. From the Networking Stack menu, type 3 to select Reset ARP Table.
Note
No confirmation prompt is displayed. All entries in the ARP table are
immediately deleted, with the exception of the “loopback” entry,
which cannot be deleted.