Allied Telesis AT-S62 - Manual (Page 291)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 291
The Create Traffic Class menu is shown in Figure 95.
Figure 95. Create Traffic Class Menu
5. Configure the parameters as needed. The parameters are described
below:
1 - Traffic Class ID
Specifies an ID number for the traffic class. Each traffic class on the
switch must be assigned a unique number. The range is 0 to 511. The
default is 0. This parameter is required.
2 - Description
Specifies a description for the traffic class. The description can be from
1 to 15 alphanumeric characters. Spaces are allowed. This parameter
is optional, but recommended. Names can help you identify the traffic
classes on the switch.
3 - Exceed Action
Specifies the action to be taken if the traffic of the traffic class exceeds
the maximum bandwidth, specified in option 6. There are two possible
exceed actions, drop and remark. If drop is selected, traffic exceeding
the bandwidth is discarded. If remark is selected, the packets are
forwarded after replacing the DSCP value with the new value specified
in option 4, Exceed Remark Value. The default is drop.
4 - Exceed Remark Value
Specifies the DSCP replacement value for traffic that exceeds the
maximum bandwidth. This value takes precedence over the DSCP
value set with option 5, DSCP Value. The default is 0.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Mar-2006
Create Traffic Class
1 - Traffic Class ID .......... 0
2 - Description ...............
3 - Exceed Action ............. Drop
4 - Exceed Remark Value ....... 0
5 - DSCP value ................
6 - Max bandwidth .............
7 - Burst Size ................
8 - Priority ..................
9 - Remark Priority ........... No
A - ToS .......................
B - Move ToS to Priority ...... No
D - Move Priority to ToS ...... No
E - Flow Group List ...........
C - Create Traffic Class
R - Return to Previous Menu
Enter your selection?