Allied Telesis AT-S62 - Manual (Page 169)

AT-S62 Management Software Menus Interface User’s Guide
Section I: Basic Operations 169
Disabling a Port Mirror
To disable a port mirror, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 21 on page 106.
2. From the Port Configuration menu, type 6 to select Port Mirroring.
The Port Mirroring menu is shown in Figure 47 on page 167.
3. Type 1 to select Enable/Disable.
The following prompt is displayed.
Enter Enable(E)/Disable(D):
4. Type D to disable the feature.
Port mirroring on the switch is now disabled. You can disconnect the
network analyzer from the destination port and use the port for normal
network operations.