Allied Telesis AT-S62 - Manual (Page 756)

Chapter 34: TACACS+ and RADIUS Authentication Protocols
756 Section VII: Management Security
The RADIUS Client Configuration menu is shown in Figure 257.
Figure 257. RADIUS Client Configuration
6. Configure the parameters as needed. The parameters are defined
here:
Global Encryption Key
This parameter specifies the encryption key for the RADIUS servers.
This option is useful if you will be entering more than one RADIUS
server and all the servers share the same encryption key. The default
is ATI.
Global Server Timeout period
This parameter specifies the maximum amount of time the switch will
wait for a response from a RADIUS server before assuming that the
server will not respond. If the timeout expires and the server has not
responded, the switch queries the next RADIUS server in the list. If
there are not any more servers, than the switch will default to the
standard Manager and Operator accounts. The default is 10 seconds.
The range is 1 to 60 seconds.
3 - RADIUS Server 1 Configuration
4 - RADIUS Server 1 Configuration
5 - RADIUS Server 1 Configuration
Use these parameters to specify the IP addresses of up to three
network servers containing the RADIUS server software. Selecting
one of the options displays the RADIUS Server Configuration menu,
shown in Figure 258 on page 757.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
RADIUS Client Configuration
1 - Global Encryption Key ............. ATI
2 - Global Server Timeout period....... 10 second(s)
3 - RADIUS Server 1 Configuration ..... 0.0.0.0
4 - RADIUS Server 2 Configuration ..... 0.0.0.0
5 - RADIUS Server 3 Configuration ..... 0.0.0.0
6 - Show Status
R - Return to Previous Menu
Enter your selection?