Allied Telesis AT-S62 - Manual (Page 494)

Chapter 22: Spanning Tree and Rapid Spanning Tree Protocols
494 Section IV: Spanning Tree Protocols
4. If you selected STP as the active spanning tree protocol, go to
“Configuring STP” on page 495 for further instructions. If you selected
RSTP, go to “Configuring RSTP” on page 501. If you selected MSTP,
go to Chapter 23, “Multiple Spanning Tree Protocol” on page 507.
Note
Once you have configured the spanning tree parameters, perform
Steps 5 through 7 to enable spanning tree.
5. To enable or disable spanning tree, type 1 to select Spanning Tree
Status.
The following prompt is displayed:
Enter new value (E-Enable, D-Disable):
6. Type E to enable spanning tree or D to disable it. The default is
disabled.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.