Allied Telesis AT-S62 - Manual (Page 498)

Chapter 22: Spanning Tree and Rapid Spanning Tree Protocols
498 Section IV: Spanning Tree Protocols
The STP Port Parameters menu is shown in Figure 165.
Figure 165. STP Port Parameters Menu
3. Type 1 to select Configure STP Port Settings.
The following prompt is displayed:
Start Port to Configure [1 to 26] ->
4. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
End Port to Configure [1 to 24] ->
5. To configure just one port, enter the same port number here as you
entered in the previous step. To configure a range of ports, enter the
last port of the range.
The Configure STP Port Settings menu is shown in Figure 166.
Figure 166. Configure STP Port Settings Menu
6. Adjust the settings as needed. The parameters are described below.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
User: Manager 11:20:02 02-Jan-2006
STP Port Parameters
1 - Configure STP Port Settings
2 - Display STP Port Configuration
R - Return to Previous Menu
Enter your selection?
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Configure STP Port Settings
Configuring Ports 4-4
1 - Port Priority ..... 128
2 - Port Cost ......... Automatic-Update
R - Return to Previous Menu
Enter your selection?