Allied Telesis AT-S62 - Manual (Page 244)

Chapter 13: Classifiers
244 Section II: Advanced Operations
Modifying a Classifier
In order to modify a classifier, you need to know its ID number. To view
classifier ID numbers, refer to “Displaying Classifiers” on page 248.
You cannot modify a classifier if it belongs to an ACL or QoS policy that is
assigned to a port. You must first remove the port assignments from the
ACL or policy before you can modify the classifier.
To modify a classifier, do the following:
1. From the Main Menu, type 7 to select Security and Services.
2. From the Security and Services menu, type 1 to select Classifier
Configuration.
The Classifier Configuration menu is shown in Figure 67 on page 241.
3. From the Classifier Configuration menu, type 2 to select Modify
Classifier.
The prompt similar to the following is displayed:
Available Classifier(s): 1-11
Enter Classifier ID : [1 to 9999] -> 1
4. Enter the ID number of the classifier you want to modify.
The Modify Classifier window is displayed. This window is identical to
the Create Classifier menus, shown in Figure 68 on page 242 and
Figure 69 on page 242.
5. Edit the variables as needed.
Note the following when modifying a classifier:
ˆ You cannot change a classifier’s ID number.
ˆ To delete a value from a variable so as to leave it blank, select the
criterion and then use the backspace key to delete its default
value.
6. Once you have adjusted the variables, type M to select Modify
Classifier.
A change to a classifier is immediately activated. If any of the settings
are incompatible, the system displays an error message. Refer to the
variable definitions in “Classifier Criteria” on page 235 for assistance in
resolving any compatibility issues.
7. To modify other classifiers, repeat this process starting with step 3.