Allied Telesis AT-S62 - Manual (Page 434)

Chapter 21: SNMPv3
434 Section III: SNMPv3
Modifying a Notify Type
To modify the Notify Type parameter in an SNMPv3 Notify Table entry,
perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 6 to select Configure
SNMPv3 Notify Table.
The Configure SNMPv3 Notify Table Menu is shown in Figure 142 on
page 430.
3. From the Configure SNMPv3 Notify Table Menu, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Notify Table is shown in Figure 143 on page 433.
4. To modify the Notify Type, type 2 to select Set Notify Type.
The following prompt is displayed:
Enter Notify Name:
5. Enter a Notify Name.
The following prompt is displayed:
Enter Notify Type [T-Trap, I-Inform]:
6. Enter one of the following message types:
T-Trap
Indicates this notify table is used to send traps. With this message
type, the switch does not expect a response from the host.
I-Inform
Indicates this notify table is used to send inform messages. With this
message type, the switch expects a response from the host.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.