Allied Telesis AT-S62 - Manual (Page 226)

Chapter 12: Event Log and Syslog Servers
226 Section II: Advanced Operations
Creating a Syslog
Server Definition
To create a syslog server definition, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 60 on page 218.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 62 on page 223.
4. Type 1 to select Create Log Output.
The following prompt is displayed:
Enter output type (1-SYSLOG) ->
5. Type 1 to select the SYSLOG option. This is the only available option.
The Syslog Server Configuration menu is shown in Figure 63.
Figure 63. Syslog Server Configuration Menu
6. Configure the parameters as needed. The parameters are defined
here:
1 - Output ID
The ID number for the syslog server definition. The definition will be
identified in the Configure Log Outputs menu by this number. The
range is 2 to 20. The default is the next available number. You cannot
use a number that is already assigned.
2 - Server IP Address
The IP address of the syslog server.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Syslog Server Configuration
1 - Output ID ....................
2 - Server IP Address ............ 0.0.0.0
3 - Message Generation ........... Disabled
4 - Message Format ............... Extended
5 - Facility Level ............... DEFAULT
6 - Event Severity ............... E,W,I
7 - Event Module ................. All
C - Create Log Output
R - Return to Previous Menu
Enter your selection?