Allied Telesis AT-S62 - Manual (Page 177)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 177
Phase 1: Creating a Configuration File
Before you begin to configure the switch with the parameter settings that
you want to save in a new configuration file, you should first create the file.
Configuring the parameters first and then creating the new configuration
file might cause you to inadvertently change a configuration file you might
not want to change.
To perform this phase, do the following:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 9 to select System
Utilities.
3. From the System Utilities menu, type 1 to select File Operations.
The File Operations menu is shown in Figure 48.
Figure 48. File Operations Menu
Option 1 - Boot Configuration File specifies the file that is updated
whenever you save a configuration change using the Save
Configuration Changes option in the Main Menu or the Save
Configuration command in the command line interface. It is also the
boot file that the switch will use the next time you reset or power cycle
the unit. Option 2 - Current Configuration specifies the boot
configuration file the switch used the last time it was reset or power
cycled.
Allied Telesyn AT-8524M Series - ATS62
Production Switch
User: Manager 11:20:02 02-Jan-2006
File Operations
1 - Boot Configuration File ............ boot.cfg (Exists)
2 - Current Configuration .............. boot.cfg
3 - Create Configuration File
4 - Copy File
5 - Rename File
6 - Delete File
7 - View File
8 - List Files
9 - Format Flash Drive
R - Return to Previous Menu
Enter your selection?