Allied Telesis AT-S62 - Manual (Page 194)

Chapter 11: File Downloads and Uploads
194 Section II: Advanced Operations
Downloading an
AT-S62 Image
from a Telnet
Management
Session
Review the “Guidelines” on page 188 before performing the following
download procedure.
To download a new AT-S62 image onto the application block portion of the
switch’s flash memory, making it the active image file on the switch, from a
Telnet management session using TFTP, perform the following procedure:
1. Establish a Telnet management session on the switch where you want
to download the new management software.
2. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
3. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 6 on page 57.
4. For the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 51 on page
190.
5. Type 1 to select Download Application Image/Bootloader.
The following prompt is displayed:
Only TFTP downloads are available for a Telnet access
TFTP Server IP address:
6. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
7. Enter the file name of the AT-S62 image file on the TFTP server to
download onto the switch. (Be sure to include the “.img” extension.)
The following message is displayed:
Getting the file from Remote TFTP Server - Please wait
...
8. If you have not already done so, start the TFTP server software.
After downloading the image file, the switch displays the following
message:
File received successfully!