Allied Telesis AT-S62 - Manual (Page 62)

Chapter 3: Basic Switch Parameters
62 Section I: Basic Operations
The Configure System Time menu is shown in Figure 8.
Figure 8. Configure System Time Menu
4. To set the system time manually, do the following:
a. Type 1 to select System Time
The following prompt appears:
Enter new system time [hh:mm:ss] ->
b. Enter a new time for the system in the following format: hours,
minutes, and seconds all separated by colons.
The following prompt appears:
Enter new system date [dd-mm-yyyy] ->
c. Enter a new date for the system. Use two numbers to specify the
day and month. Use four numbers to specify the year. Separate the
values with hyphens. For example, December 5, 2003 is specified
05-12-2003.
The new time and date are immediately activated on the switch.
5. To configure the switch to obtain its date and time from an SNTP or
NTP server on your network or the Internet, do the following:
a. Type 3 to select SNTP Server to enter the IP address of an SNTP
server.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Configure System Time
1 - System Time ................... 00:04:22 on 01-Jan-1980
2 - SNTP Status ................... Disabled
3 - SNTP Server ................... 0.0.0.0
4 - UTC Offset .................... +0
5 - Daylight Savings Time (DST) ... Enabled
6 - Poll Interval ................. 600 seconds
7 - Last Delta .................... +0 seconds
U - Update System Time
R - Return to Previous Menu
Enter your selection?