Allied Telesis AT-S62 - Manual (Page 42)

Chapter 2: Starting a Local or Telnet Management Session
42 Section I: Basic Operations
settings, enter “operator” as the user name. The default password for
operator access is “operator”. Usernames and passwords are case-
sensitive. For information on the two access levels, refer to
“Management Access Levels” on page 35. (For instructions on how to
change a password, refer to “Configuring the Manager and Operator
Passwords” on page 58.)
After logging on, you will see the window in Figure 2. This is the
command prompt interface. You will see either a “#” symbol if you
logged on as a manager or a “$” symbol if you logged on as an
operator.
Figure 2. Command Prompt
For instructions on how to use the command line interface, refer to the
AT-S62 Command Line User’s Guide, which is available from the
Allied Telesyn web site.
5. To display the menu interface, type menu at the command prompt.
The Main Menu is shown in Figure 3.
Figure 3. Main Menu
To select a menu item, type the corresponding letter or number.
Pressing the Esc key or typing the letter R in a submenu, returns you to
the previous menu.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
#
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
User: Manager 11:20:02 02-Jan-2006
Main Menu
1 - Port Configuration
2 - VLAN Configuration
3 - Spanning Tree Configuration
4 - MAC Address Tables
5 - System Administration
6 - Advanced Configuration
7 - Security and Services
8 - Enhanced Stacking
C - Command Line Interface
Q - Quit
Enter your selection?