Allied Telesis AT-S62 - Manual (Page 629)

AT-S62 Management Software Menus Interface User’s Guide
Section V: VLANs 629
Note
You cannot delete the Default_VLAN, which has a VID of 1.
The Delete VLAN Menu expands to contain all relevant information
about the VLAN, as shown in Figure 217.
Figure 217. Expanded Delete VLAN Menu
6. Type D to delete the VLAN or R to cancel the procedure.
If you select to delete the VLAN, the following confirmation prompt is
displayed:
Are you sure you want to delete this VLAN [Yes/No] ->
7. Type Y to delete the VLAN or N to cancel the procedure. Press Return.
If you select Yes, the VLAN is deleted and the following message is
displayed:
SUCCESS
Please make sure to manually delete any static multicast
MAC address(es) entries for this VLAN
Press any key to continue ...
All untagged ports in the deleted VLAN are returned to the
Default_VLAN as untagged ports.
Any static addresses assigned to the ports of the VLAN are now
obsolete, because the VLAN has been deleted. Those addresses
should be deleted from the MAC address table. For instructions on
how to delete addresses, refer to “Deleting Unicast and Multicast MAC
Addresses” on page 132.
8. Press any key.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
Delete VLAN
1 - VLAN Name .............. Internet_VLAN
2 - VLAN ID (VID) .......... 3
3 - Tagged Ports ........... 25
4 - Untagged Ports ......... 12-24
5 - Protected Ports ........ Yes
D - Delete VLAN
R - Return to Previous Menu
Enter your selection?