Allied Telesis AT-S62 - Manual (Page 438)

Chapter 21: SNMPv3
438 Section III: SNMPv3
5. Enter the IP address of the host.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
The following prompt is displayed:
Enter UDP Port#: [0 to 65535]-> 162
6. Enter a UDP port.
You can enter a UDP port in the range of 0 to 65,535. The default UDP
port is 162.
The following prompt is displayed:
Enter Timeout (10mS): [0 to 2147483647]-> 1500
7. Enter a timeout value in milliseconds.
When an Inform message is generated, it requires a response from the
switch. The timeout value determines how long the switch considers
the Inform message an active message. This parameter applies to
Inform messages only. The range is from 0 to 2,147,483,647
milliseconds. The default value is 1500 milliseconds.
The following prompt is displayed:
Enter Retries:[0 to 255]-> 3
8. Enter the number of times the switch will retry, or resend, an Inform
message.
When an Inform message is generated, it requires a response from the
switch. This parameter determines how many times the switch
resends an Inform message. The Retries parameter applies to Inform
messages only. The range is 0 to 255 retries. The default is 3 retries.
The following prompt is displayed:
Enter Tag List:
9. Enter a Tag List.
This list consists of a tag or list of tags you configured in a Configure
SNMPv3 Notify Table entry with the Notify Tag parameter. See
“Creating an SNMPv3 Notify Table Entry” on page 429. Enter a Tag
List of up to 256 alphanumeric characters. Use a space to separate
entries, for example:
hwengtag swengtag testengtag
The following prompt is displayed:
Enter Target Parameters: