Allied Telesis AT-S62 - Manual (Page 131)

AT-S62 Management Software Menus Interface User’s Guide
Section I: Basic Operations 131
If you are entering a static multicast address, you must specify the port
when the multicast application is located as well as the ports where the
host nodes are connected. Assigning the address only to the port
where the multicast application is located will prevent the forwarding of
the multicast packets to the host nodes. You can specify the ports
individually (e.g., 1,4,5), as a range (e.g., 11-14) or both (e.g., 15-
17,22,24).
The following prompt is displayed:
Please enter VLAN ID: [1 to 4094] -> 1
7. Enter the VLAN ID where the port is a member.
8. Repeat this procedure starting with Step 3 to enter additional static
unicast or multicast MAC addresses.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.