Allied Telesis AT-S62 - Manual (Page 396)

Chapter 21: SNMPv3
396 Section III: SNMPv3
Configuring the SNMPv3 View Table
This section contains a description of the SNMPv3 View Table and how to
create, delete, and modify table entries. Creating this table, allows you to
specify a view using the following parameters:
ˆ Subtree OID
ˆ Subtree Mask
ˆ MIB OID Table View
To configure the SNMPv3 View Table, you need to be very familiar with
the MIB tree. You can be very specific about the view a user can or cannot
access—down to a column or row of the tree. AT-S62 supports the
Internet subtree of the MIB tree. See RFC 2575 for detailed information
about defining a view.
There are three functions you can perform with the SNMPv3 User Table.
ˆ “Creating an SNMPv3 View Table Entry” on page 396
ˆ “Deleting an SNMPv3 View Table Entry” on page 399
ˆ “Modifying an SNMPv3 View Table Entry” on page 400
Creating an
SNMPv3 View
Table Entry
To create an entry in the SNMPv3 View Table, perform the following
procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 3 to select Configure
SNMPv3 View Table.