Allied Telesis AT-S62 - Manual (Page 203)

AT-S62 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 203
These guidelines apply to an Xmodem download:
ˆ Xmodem can only download a file onto the switch where you started
the local management session. You cannot use Xmodem to download
a file onto a switch accessed through enhanced stacking.
ˆ The file to be downloaded must be stored on the computer or terminal
connected to the RS232 Terminal Port on the switch.
These guidelines apply to a TFTP download:
ˆ Your network must have a node with TFTP server software.
ˆ The file to be downloaded must be stored on the TFTP server.
ˆ You should start the TFTP server software before you begin the
download procedure.
ˆ The switch where you are downloading the file must have an IP
address and subnet mask, such as a master switch of an enhanced
stack. For switches without an IP address, such as slave switches, you
can download the file from a local management session of the switch
using Xmodem.
Downloading a
File from a Local
Management
Session
Review “Guidelines” on page 202 before performing this procedure.
To download a file onto a switch from a local management session using
Xmodem or TFTP, perform the following procedure:
1. Establish a local management session on the switch where you want
to download the system file.
2. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 52.
3. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 6 on page 57.
4. For the System Utilities menu, type 2 to select Downloads and
Uploads.
The Downloads and Uploads menu is shown in Figure 51 on page 190.
5. Type 3 to select Download a File.
The following prompt is displayed:
Download Method/Protocol [X-Xmodem, T-TFTP]: