Allied Telesis AT-S62 - Manual (Page 405)

AT-S62 Management Software Menus Interface User’s Guide
Section III: SNMPv3 405
Configuring the SNMPv3 Access Table
This section contains a description of the SNMPv3 Access Table and how
to create, delete, and modify table entries. The SNMPv3 Access Table
allows you to configure a security group. Each user must belong to a
security group. After you have configured a security group, use the
SecurityToGroup Table to assign users to security groups. See “Creating
an SNMPv3 SecurityToGroup Table Entry” on page 421.
For each security group, you can assign the following attributes:
ˆ a Security Model (SNMPv1, SNMPv2c, SNMPv3)
ˆ Read, write, and notify views
ˆ A security level
ˆ A storage type
Before you begin this procedure, you will need to configure entries in the
View Table. These values are used to configure the Read, Write, and
Notify View parameters in this procedure. See “Configuring the SNMPv3
View Table” on page 396.
There are three functions you can perform with the SNMPv3 Access
Table.
ˆ “Creating an SNMPv3 Access Table Entry” on page 405
ˆ “Deleting an SNMPv3 Access Table Entry” on page 409
ˆ “Modifying an SNMPv3 Access Table Entry” on page 411
Creating an
SNMPv3 Access
Table Entry
To create an entry in the SNMPv3 Access Table, perform the following
procedure.
1. Follow steps 1 through 3 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387.
2. From the Configure SNMPv3 Table Menu, type 4 to select Configure
SNMPv3 Access Table.