Allied Telesis AT-S62 - Manual (Page 665)

AT-S62 Management Software Menus Interface User’s Guide
Section VI: Port Security 665
Configuring Authenticator Port Parameters
Note
A port must already be set to the authenticator role before you can
configure its settings. For instructions on how to change the role of a
port, refer to “Setting Port Roles” on page 662.
To configure the parameters of an authenticator port, perform the following
procedure:
1. From the Main Menu, type 7 to select Security and Services.
The Security and Services menu is shown in Figure 103 on page 313.
2. From the Security and Services menu, type 2 to select Port Access
Control (802.1X).
The Port Access Control (802.1X) menu is shown in Figure 229 on
page 662.
3. From the Port Access Control menu, type 4 to select Configure
Authenticator.
The Configure Authenticator menu is shown in Figure 231.
Figure 231. Configure Authenticator Menu
4. From the Configure Authenticator menu, type 1 to select Configure
Authenticator Port Access Parameters.
The following prompt is displayed:
Enter port list ->
5. Enter the authenticator port number whose parameters you want to
change. You can configure more than one port at a time.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Marketing
User: Manager 11:20:02 02-Mar-2006
Configure Authenticator
1 - Configure Authenticator Port Access Parameters
2 - Display Authenticator Port Access Parameters
R - Return to Previous Menu
Enter your selection?