Allied Telesis AT-S62 - Manual (Page 753)

AT-S62 Management Software Menus Interface User’s Guide
Section VII: Management Security 753
5. To configure the TACACS+ parameters, type 3 to select TACACS+
Configuration.
The TACACS+ Client Configuration menu is shown in Figure 256.
Figure 256. TACACS+ Client Configuration Menu
6. Configure the settings as needed. The settings are described below:
1 - TAC Server 1
2 - TAC Server 2
3 - TAC Server 3
Use these parameters to specify the IP addresses of up to three
network servers containing TACACS+ server software. After you have
entered an IP address, you will see the following prompt:
Use per-server secret [Y/N] ->
If you will be specifying more than one TACACS+ server and if all of
the servers use the same encryption secret, you can answer No to this
prompt and enter the encryption secret using the TAC Global Secret
parameter.
However, if you are specifying only one TACACS+ server or if the
servers have difference encryption secrets, then respond with Yes to
this prompt. You will see:
Enter per-server secret [max 40 characters] ->
Use this prompt to enter the encryption secret for the TACACS+ server
whose IP address you are specifying.
4 - TAC Global Secret
If all of the TACACS+ servers have the same encryption secret, rather
then entering the same secret when you enter the IP addresses, you
can use this option to enter the secret just once.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
User: Manager 11:20:02 02-Jan-2006
TACACS+ Client Configuration
1 - TAC Server 1 .................. 0.0.0.0
2 - TAC Server 2 .................. 0.0.0.0
3 - TAC Server 3 .................. 0.0.0.0
4 - TAC Global Secret .............
5 - TAC Timeout ................... 10 seconds
R - Return to Previous Menu
Enter your selection?