beautypg.com

Deleting an snmpv3 notify table entry – Allied Telesis AT-S62 User Manual

Page 431

background image

AT-S62 Management Software Menus Interface User’s Guide

Section III: SNMPv3

431

I-Inform
Indicates this notify table is used to send inform messages. With this
message type, the switch expects a response from the authoritative
entity.

The following prompt is displayed:

Enter Storage Type [V-Volatile, N-NonVolatile]:

7. Select one of the following storage types for this table entry:

V - Volatile
Select this storage type if you do not want the ability to save an entry in
the SNMPv3 Notify Table to the configuration file. After making
changes to an SNMPv3 Notify Table entry with a Volatile storage type,
the S - Save Configuration Changes option does not appear on the
Main Menu.

N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Notify Table to the configuration file. After making changes to
an SNMPv3 Notify Table entry with a NonVolatile storage type, the S -
Save Configuration Changes option appears on the Main Menu,
allowing you to save your changes.

Note

The Row Status parameter is a read-only field in the Telnet and
Local interfaces. The Active value indicates the SNMPv3 Notify
Table entry takes effect immediately.

8. After making changes, type R until you return to the Main Menu. Then

type S to select Save Configuration Changes.

Deleting an

SNMPv3 Notify

Table Entry

You may want to delete an entry from the Configure SNMPv3 Notify Table
Menu. When you delete a Configure SNMPv3 Notify Table entry, there is
no way to undelete, or recover, it.

To delete an entry in the Configure SNMPv3 Notify Table Menu, perform
the following procedure:

1. Follow steps 1 through 3 in the procedure described in “Creating an

SNMPv3 User Table Entry” on page 386. Or, from the Main Menu type
5->5->5.

The Configure SNMPv3 Table Menu is shown in Figure 133 on page
387
.

2. From the Configure SNMPv3 Table Menu, type 6 to select Configure

SNMPv3 Notify Table.